|
||||||||||||||||||||||||||||||||||||||||||||||||||||||
|
Home | Business | Small Business The procedure to be followed for making a vaporizer is as follows. Firstly flat wood should be cut into a triangle with equal eight inch sides at sixty degree angles. Then wood needs to be stained and varnished. Varnishing is required so that pests do not destroy it. Then selection has to be made as to which side will be top of vaporizer. Then find the exact center of the triangle and mark it on both top and bottom. Then by using a drill make a hole of the size such that soldering handle can be set into it and rim lies on top. This particular size has to be drilled out in centre of triangular piece. Then the triangular piece should be turned over and has to be marked with 3 spots each about 1 inch from the vertex each angle. Again drilling is required of each of these. Then turn the triangular piece to the top. Next step is to pull the plastic bottom piece off of the 2 liter bottle and then cut out the middle of this piece. Then place the black piece over the hole in the center of the wooden triangle and put a two nails through it into the wood. Hot glue can be used for the purpose of filling ant cracks in bottle. Article Source: http://www.articlewheel.com
Savey Bakarne is a retail saleswoman who has 20 years of experience buying and selling health products that are good technologically advanced. She specializes in helping her customers find the right health products from aromotherapy to finding the right www.vapeworld.com "> Vaproizer for your needs.
|
 RSS Feeds by Category |
|||||||||||||||||||||||||||||||||||||||||||||||||||||
