|
||||||||||||||||||||||||||||||||||||||||||||||||||||||
|
Home | Business | Customer Service Now you are geared up to start marking the spot for your coat rack measure from the floor in roughly the center of your selected spot and locate a cut of masking tape on the wall and mark the preferred elevation on the cut of masking tape, the use of the masking tape thwarts drawing directly on the wall. Using your level, yet again you can use a torpedo level place the level or laser on your mark and hold it horizontal and mark the left and right ends of the placement of the coat rack. If a torpedo level or laser is not on hand you can acquire a piece of masking tape roughly the length of the coat rack and position it on the wall horizontally, stand back a little distance and carefully check out the masking tape does it look parallel to the floor? if not adjust until you have a nice horizontal masking tape line. After you obtain a nice parallel masking tape line to show you in the putting up of your coat rack. The studs placement need to be established. The piece of masking tape that was put up previous is the best position to indicate the midpoint of each stud. A stud locator is the customary apparatus used for locating the wall studs, a stud locator can be purchased for roughly $8.00. Examine the wall over for a nail pop in the drywall or use a magnet to find a drywall nail. Wall studs are located every 16 inches on center. Our coat rack is now ready to install if your coat rack employees a straight through holding scheme, situate your coat rack on the earlier set up level mark positioned on the masking tape. Make use of one of the mounting screws place it through the mounting hole and put a mark on the wall, duplicate this for all mounting holes. If your coat rack utilizes a key-hole mounting you will need to measure the distance relating to the key-holes and shift these measurements to the masking tape. When the key-holes are marked you need to pre-drill the fastener key holes, make sure the screws and select a drill bit smaller than the fastener and bore the holes. If you are putting up the coat rack with the trough hole mounting usage hold up the coat rack on the level line and predrilled holes introduce the mounting screws and snug them evenly. If you are making use of the key-hole mounting usage introduce the screws tighten them until the head of the screws sticks out roughly 1/4 of an inch from the wall, put the coat rack over the screws and slide down. You’re new coat rack is now ready for coats. Article Source: http://www.articlewheel.com
About the Author: Thomas Oak he writes for www.pegandrail.com check out thier line of white wall coat racks or their complete line of hand crafted wall coat hooks for your home or office.
|
 RSS Feeds by Category |
|||||||||||||||||||||||||||||||||||||||||||||||||||||
